Category Archives: Technical

FANUC R-30iA – How To Remaster A Single Axis

Remastering a single axis. Note: When remastering axis 2 or 3, both axis 2 and 3 must be remastered due axis 2/3 coupling. Press the COORD key. Cycle through to the JOINT coordinates. Press ENTER key. Enable teach pendant DEADMAN switch. Turn teach pendant switch to ON position. Move robot axis approximately 15 degrees pastContinue reading “FANUC R-30iA – How To Remaster A Single Axis”

FANUC R-30iB – How To Remaster A Single Axis

Remastering a single axis. Note: When remastering axis 2 or 3, both axis 2 and 3 must be remastered due axis 2/3 coupling. Press the COORD key. Cycle through to the JOINT coordinates. Press ENTER key. Enable teach pendant DEADMAN switch. Turn teach pendant switch to ON position. Move robot axis approximately 15 degrees pastContinue reading “FANUC R-30iB – How To Remaster A Single Axis”

Benshaw-(RB2, RC2, RX2E) How To Set Passcode

Purpose: This will unlock advanced parameters. The following steps must be performed to set a passcode using the KPMX3CBL2M LCD Display: At the default meter display, press the MENU key to enter the Menu mode. Press the UP or DOWN keys to get to the FUN parameters. Press the ENTER key Press the UP orContinue reading “Benshaw-(RB2, RC2, RX2E) How To Set Passcode”